
This Kanata patio door had become hard to slide. We took the sliding panel out, replaced its rollers, cleaned the bottom track and put the door back, so it rolls easily again.
The problem
The door took real effort to push open and closed. The bottom track was packed with dirt and grit, and the rollers in the bottom of the panel were no longer rolling freely. When rollers wear, the panel drags on the track instead of riding on it.

Replacing the rollers
Patio door rollers sit inside the bottom of the sliding panel, so the panel has to come out of its track. We lifted it out and laid it down on the patio to work on it, then fitted new rollers in the bottom of the panel.

Cleaning the track
New rollers will not run smoothly on a dirty track, so before the panel went back in we vacuumed the bottom track and wiped out the channel by hand.



The result
With new rollers and a clean track, the panel slides with a light push again.
Signs your patio door rollers need replacing
- The door takes more effort to open than it used to, or sticks partway.
- You hear grinding or scraping as it slides.
- The panel sits low or the latch no longer lines up with the keeper.
Vacuuming the track is a good first step. If the door is still heavy afterwards, the rollers are usually the cause. See patio door roller replacement in Kanata, sliding door roller repair in Kanata and patio door repair in Kanata, or try the Door Problem Finder.
Patio door hard to slide?
Send us a photo or a short video of the door sliding. We will tell you whether it needs a track cleaning, new rollers or both, and give you a free quote before any work starts.




