
At this ground-floor commercial unit in Ottawa, the large glass panel beside the entrance door had shattered. The glass was cracked from edge to edge but still hanging in the frame. The aluminum frame and the door itself were fine, so we removed the broken glass and installed a new panel in the existing frame.
What we found
The entrance is an aluminum storefront: a single glass door with a pull handle and lock, and large fixed glass panels on either side under a transom. The tall panel next to the door had broken into a web of small cracks across its whole surface.
That pattern is how tempered safety glass breaks. Instead of falling out in large, sharp pieces, it crazes into small fragments that hold together, at least for a while. A panel in that state can let go with a knock, a gust of wind or the vibration of the door closing, so it should not be left that way for long.

Replacing the glass
Storefront glass is held in the aluminum frame by glazing stops and gaskets. To replace it, the stops are removed, the broken glass is taken out carefully, the frame pocket is cleaned of fragments and old gasket, and the new panel is set on setting blocks, then held in with the stops and new gaskets so it sits evenly and seals.
The frame, the entrance door and the panels on either side did not need to be touched.

If your storefront glass is broken
- Keep people away from the panel, inside and outside, especially if it is crazed but still in the frame.
- Take photos of the damage for your insurer before anything is moved.
- Call us. If the glass has to be ordered, we secure the opening first; see emergency board-up.
- Check the door and hardware at the same time; see glass storefront door repair and storefront door repair.
For other glass work, see broken glass repair and commercial door repair.
Broken storefront or door glass?
Send us a photo of the glass and the frame. We will tell you what is needed and give you a flat-rate quote before any work starts.




